Beşel Floor Bumper 50 mm Satin (400 Pieces)

Beşel Floor Stop 50 mm Satin — 400 Pieces

Beşel 50 mm Satin Floor Stop is a practical fitting that prevents doors and cabinet leaves from striking walls, floors, or surfaces when opened, absorbing impact noise and protecting finishes. The satin‑plated finish ensures visual consistency, while the carton of 400 offers cost‑effective stock for workshops, serial production, and large‑scale projects.

Technical Specifications

• Brand: Beşel
• Model: Floor‑Mounted Door Stop
• Diameter: 50 mm
• Finish: Satin / Matte Nickel — perfectly matches hinges and handles from the same range
• Body: Metal construction with satin‑finished visible surface
• Buffer Tip: Flexible impact‑absorbing black rubber / TPE insert
• Mounting: Surface‑fix, base screw‑down
• Fixing Pattern: Standard 2 holes — widely compatible
• Height: Base thickness approx. 8–10 mm; total height including rubber tip 12–14 mm
• Pack: 400 Pieces per carton

Applications

• Solid wood, panelled, and MDF interior doors
• Wardrobes, kitchen units, and large cabinet doors
• Office partition doors, display cases, and service hatches
• Headboards, consoles, and furniture edges at risk of impact
• High‑traffic public buildings — schools, hospitals, commercial premises
• Refurbishment — direct replacement for existing stops of matching size

Product Advantages

• Impact & Noise Reduction: Doors stop gently without striking the wall; metallic clatter and loud impact are eliminated
• Surface Protection: Prevents scuffs, paint chipping, tile damage, and veneer crushing on walls and door edges
• Coordinated Appearance: Satin finish creates a unified look with matching hinges, handles, and fittings — discreet and refined
• Flexible Buffer: Soft rubber insert dissipates impact energy; resists hardening or cracking over time
• Robust Metal Base: Rigid body maintains its shape for years; far less prone to breaking than plastic alternatives
• Economical Bulk Pack: 400‑piece carton substantially lowers unit cost — ideal for workshops and ongoing production

Installation Guidelines

• Position the stop at the point farthest from the hinge, close to the floor or lower edge in the direction of opening
• Mark so the rubber tip contacts the wall when the door is fully open; typically placed near the hinge‑side bottom corner
• Select suitable fixings — wood screws for timber; wall plugs + screws for concrete/masonry
• Install screws loosely first; check alignment and contact, then tighten fully once positioned correctly
• If height is insufficient due to deep carpet, high thresholds, or thick flooring, use spacing washers to raise the stop

Frequently Asked Questions

1. What does 50 mm mean?
It refers to the body diameter. The broad 50 mm footprint spreads load over a wide area, offering stable support especially for heavier and larger doors.

2. Does the rubber wear out — can it be replaced?
The tip can be replaced as a single part if worn; the metal body remains in place, extending service life and reducing replacement cost.

3. Suitable for exterior doors?
The satin finish is optimised for interior use. For doors exposed to rain, frost, and constant weathering, choose stainless‑steel exterior‑grade stops.

4. Will this replace an existing stop?
Yes, if diameter and hole spacing match. Minor misalignment can be accommodated within screw tolerance; one new hole may be needed in rare cases.

5. How many should I fit?
One is usually sufficient for a standard door. On wide or heavy leaves, fit two — top and bottom — to balance force and prevent sagging.